EM-1010 computerized Embroidery Machine Operation Manual V2.0
16
4.3-6-2 Applique Offset, Low Speed Embroidering and Needle Bar
Replacement
If a certain color changing sequence that the cursor is located requires offset out of
taboure (appliqué) at the end of embroidery, press
key once before No Input
needle bar and “F” is displayed behind current needle bar number. If to cancel offset out of
taboure setting, press
once again.
If a certain color changing sequence that the cursor is located requires deceleration for
embroidery at the embroidery (slowed speed is set at “low embroidering speed” in “speed
parameters” of embroidery parameters), press
key once before No Input needle
bar and “F” is displayed behind current needle bar number. If to cancel low embroidering
speed setting, press
once again.
If all color changing sequences of a certain set needle bar shall be replaced by another
needle bar for embroidering, after pressing
key, click the needle bar for replacement,
all identical needle bars are selected, Replace needle bar values according to requirements.
Press
key once again to exit replacement operation.
After the setting is completed, press
key to save current setting.
4.3-6-3 Multi-tinsel Design
If current color changing sequence is tinsel embroidery, press
key to take free
combination design of multi-tinsel (mechanical part must be supported). If current color
changing is not tinsel embroidery, press the key and it cannot enter into operation.
After entering into setting interface,
displays max tinssel number of
current color changing. Select the application method: A/B/AB according to requirments.
Selected background has color hcnaging. Input current output number in the input box after
the option. It can use max 9 kinds of combinations.
