5-20
Confidential
1.3.12 Adjust printable range for each speed level (Function code 46)
<Function>
This function is to adjust the printing position in horizontal / vertical direction.
Position can be adjusted in 11 steps from -0.5% to 0.5% (Printing width gets smaller when
the value is negative).
<Operating Procedure>
(1) Press the [4], and then the [6] in the initial state of maintenance mode. For models
without keypad, press the [
▲
] or [
▼
] to display “MAINTENANCE 46” on the LCD and
press the [OK]. “MAIN SIZE SET” is displayed on the LCD.
(2) Press the [
▲
] or [
▼
] to display “PRINT TEST PTN” on the LCD, and press the [SET] or
[OK]. “PRINTING” is displayed on the LCD, and the print adjustment test pattern (refer to
the
) is printed on a sheet of paper.
(3) Adjust the line so that the width is 10 mm in horizontal / vertical direction. Press the [
▲
]
or [
▼
] to display desired direction on the LCD.
• Horizontal direction
→
“MAIN SIZE SET”
• Vertical direction
→
“SUB SIZE SET”
Press the [SET] or [OK]. “SET: 0.0 %” is displayed on the LCD.
(4) To make the print width smaller, press the [
▼
] to decrease the value. Press the [SET] or
[OK] after adjusting the value.
(5) After adjustment, repeat the procedure (2) to check if the adjustment was correctly done.
(6) Press the [X] or [Stop] to return the machine to the initial state of maintenance mode
after adjusting the value.
Содержание SP 230SFNw
