Ricoh RCP40, Руководство по эксплуатации

Страница: 48 / 58

Using the Control Panel
42
5
Online Parameter Settings
No. Mode Description
1 Set aut-O/L def. Sets Auto On Line to “ON” or “OFF” when the power has been
turned on, or when the mode has been cleared.
Note
❒
Default: ON
2 Print Size def. Sets the print size selected when the power has been turned on or
when the mode has been cleared.
Note
❒
Default: Auto
3 List/Test Print Prints the current set content of this machine.
Note
❒
Default: System Print
5 IP Address Sets the IP Address.
Note
❒
Default: 011.022.033.044
Reference
See Printer Reference 1 for information about the IP Address
setting.
6 Ethernet Speed Sets the Ethernet communication speed.
Note
❒
Default: Auto
7 Network Sets the Network boot.
Note
❒
Default: None
Reference
See Printer Reference 1 for information about the Network boot
setting.
8 I/O Timeout Sets the time to enable the interface after data stops being re-
ceived. When the time set here is exceeded, it will be possible to
receive data from the other interface.
Important
❒
If the set time is too short, a time out might occur while one
data is being received. As a result, data from another interface
might cut in and be printed, or the emulation retrieval from
half of the data may be activated, and be replaced with a dif-
ferent emulation.
Note
❒
Default: 30 sec.