English
57
English
Replacing the lamp
The projector will detect the lamp life itself. It will show you a
warning message
Warning! Lamp
Lamp is approaching the end of its useful life.
Replacement Suggested!
When you see this message, change the lamp as soon as
possible. Make sure the projector has been cooled down for at
least 60 minutes before changing the lamp.
Warning: To avoid
burns, allow the
projector to cool for
at least 60 minutes
before you replace the
lamp!
Warning: Do not drop
the lamp module or
touch the glass parts.
The glass parts may
shatter and cause
injury if it is dropped.
Warning: For
continued safety
replace with
Replacement Lamp
Type 23.
Caution: If the lamp
should break, handle
with care to avoid
injury due to broken
pieces and contact your
sales representative for
repair service.
Lamp Replacing Procedure:
1. Switch off the power to the projector by pressing the
button.
2. Allow the projector to cool down at least 60 minutes.
3. Disconnect the power cord.
4. Remove the screws on the top cover.
5. Remove the top cover.
6. Remove the screw on the lamp cover.
7. Slide the lamp cover to the side and remove the cover.
8. Remove the screw on the lamp module.
9. Pull out the lamp connector.
10. Lift up the lamp handle.
11. Carefully remove the lamp module.
12. Install the new lamp module by reversing the previous steps.
See the lamp’s manual for instructions on resetting the lamp
time.
3
2
6
4
1
5
7
8
