Ricoh Network Scanning Unit A, Руководство по эксплуатации, Страница: 161 / 206

Printing Scan Data
153
8
H
If you wish to set a custom ra-
tio for
[ Enlarge ] or [ Reduce ] ,
highlight the nearest preset ra-
tio, by pressing
[ Zoom ] , and
then use the Number keys
(otherwise
[ - ] or [ + ] ) to specify
the ratio.
I
Press [ OK ] .
This saves the ratio you have
entered, and returns to the sec-
ond page of the Print Settings
screen (Print Settings 2/2).
Note
❒
Pressing
[ Cancel ]
discards the
setting you have entered,
and returns to the previous
screen.
J
When you are finished, press
[ Exit ] .
This returns to the Print Settings
screen.
K
Press [ OK ] .
This returns to the Print Scan
standby screen, and the Print
Settings are displayed on the
third line of the screen.
Confirming Print Settings
You can confirm the current Print Set-
tings, or the Print Settings that you
have registered to
[ Default ] , [ User 1 ] ,
[ User 2 ] or [ User 3 ] .
Note
❒
You can confirm the [ Default ] set-
tings by selecting
[ Manual ]
in the
step
B
below, unless you configure
the Print Settings manually. After
you have manually configured the
Print Settings, selecting
[ Manual ]
displays the current settings.
AAAA
While the Print Scan Ready screen
is displayed, press
[ Settings ] .
The Print Settings screen is dis-
played.
BBBB
Use the
{{{{ 1 1 1 1 }}}}
or
{{{{ 0 0 0 0 }}}}
key to high-
light [ Manual ] , [ User 1 ] , [ User 2 ] or
[ User 3 ] on the screen, and then
press [ Status ] .
The status screen of your selection
appears.
CCCC
Use [
↓↓↓↓
Next ] or [
↑↑↑↑
Prev. ] to display
the setting of the setup item you
wish to confirm.
DDDD
When you are finished, press
[ Exit ]
.