Ricoh M178-21, Руководство по обслуживанию на месте

Страница: 212 / 252

Refillable Printer, 3in1
Operators do not know when to change the AIO.
Make sure the operators understand the following points about AIO replacement:
• For the Refillable Printer, 3in1 the machine does not monitor the level of toner remaining in the AIO.
There is no toner near-end or toner-end alert.
• The AIO should be replaced or refilled when images become pale or scratchy.
• The yield of the starter AIO is 500 sheets and the yield of a replacement AIO is 2,000/1,200
sheets.
• A replacement AIO can be refilled up to three times. This is calculated based on the service life of
the drum.
• An AIO must be refilled by a trained service technician.
4in1 and unrefillable printer, 3in1
The machine has issued a toner end alert but some toner remains in the AIO.
Cause 1 The service life of the drum has expired before the toner supply has run out.
Solution 1 Replace the AIO
Solution 2 Disable the toner end function in order to use up all the toner in the AIO
(4in1 only).
[User Tools] > System Settings > Toner End Option > Continue Printing
Comments -
Cause 2 A supply AIO (2,000/1,200 print capacity) was installed at installation
(the starter AIO was not installed at installation),
Solution Disable the toner end function in order to use up all the toner in the AIO
(4in1 only): [User Tools] > System Settings > Toner End Option > Continue
Printing
Comments • The machine toner count is set for installation of the starter AIO (500
print capacity) when the machine is removed from the box.
• If a supply AIO (2,000 print capacity) is installed at installation, the
machine will signal near end and toner end after only 500 prints.
• The starter AIO should always be installed at installation and then used
until it is empty.
6. Troubleshooting
210