Ricoh LD520CL, Руководство по эксплуатации

Страница: 551 / 956

Setting Paper on the Bypass Tray
This section gives instructions for setting paper on the bypass tray.
For details about paper size and paper type, see "Paper Size and Paper Type", About This Machine.
• Paper sizes that can be loaded onto the bypass tray are 90-305 mm (3.55-12.00 in.) vertical, and
148-600 mm (5.83-23.62 in.) horizontal.
• When paper larger than 600 mm (23.62 in.) in length is used, the paper may become wrinkled, may
not be fed into the machine, or may cause paper jams.
• The machine can automatically detect the following sizes as regular size copy paper:
• A3 , A4 , A5
• 11 " 17 " , 8
1
/
2
" 11 " , 5
1
/
2
" 8
1
/
2
"
• If you want to use the size of paper other than the above, be sure to specify the size.
• The following functions are disabled when printing from the bypass tray:
• Duplex printing
• Auto Tray Select
• Auto Tray Switching
• Rotating Collate
• Certain types of OHP transparencies for color printing cannot be used. For details about types that
can be used, contact your sales or service representative.
1. Open the bypass tray.
BLF005S
2. Gently insert paper face down into the bypass tray until the beeper sounds, and then adjust
the paper guides to the paper size.
If the paper size of the paper guide and the paper do not match, skewing and misfeeds might occur.
Do not stack paper over the limit mark, otherwise a skewed image or misfeeds might occur.
Open out the extender to support paper sizes larger than A4 , 8
1
/
2
" 11 " .
13