7
7-11
Starting and shutting down the E-820
Starting and shutting down the E-820
Generally, you can leave the E-820 running all the time. This section describes how to
shut down and restart the E-820 when necessary.
Starting the E-820
To start the E-820, move the power switch on the back of the E-820 to the On
position. If the copier is also turned off, turn it on before turning on the E-820.
Diagnostic messages appear on the E-820 Control Panel. If any diagnostics fail, more
information and instructions appear. Contact your service representative if the E-820
encounters problems while running the diagnostics. The E-820 continues starting up
and displays the message Idle when it is ready to receive data.
N
OTE
:
If an Administrator password has been set, you are required to enter it to
access Setup.
If you press a button, the following options appear.
Choose
To do this
Exit Setup
Exit the Setup menus; the E-820 reboots.
Server Setup
Enter the Server Setup menus.
Network Setup
Enter the Network Setup menus.
Printer Setup
Enter the Printer Setup menus.
PS Setup
Enter the PostScript Setup menu.
Color Setup
Enter the Color Setup menu.
Job Log Setup
Enter the Job Log Setup menu.
Change Password
Change the Administrator password.
