Ricoh D391, Руководство по обслуживанию

Страница: 342 / 490

Other Adjustments
Signature Exit Motor Adjustment
Do this procedure when you see that the signature is not feeding properly to the trimming unit (this adjustment
changes the length of time that the signature exit roller remains in contact with the signature during transport
to the trimming).
1. Set the SW1 bank as shown below.
SW1
1 2 3 4
Up * * *
2. Set the SW2 bank as shown below.
SW2
1 2 3 4 5 6 7 8
Up * * Up * Up * *
3. Push [PSW1] then look at LED1, LED2, LED3 to read the current setting.
4. Push [PSW2] to add 0.1 mm to the current value.
-or-
Push [PSW3] to subtract 0.1 mm from the current value.
• To increase the length of time the signature exit roller remains in contact with the signature when
it is transported to the trimming unit, adjust in the plus (+) direction.
• To decrease the length of time the signature exit roller remains in contact with the signature when
it is transported to the trimming unit, adjust in the minus (-) direction.
5. LED1, LED2, LED3 light for 300 ms.
6. Look at LED1, LED2, LED3 to read the new adjusted value.
7. Repeat the steps above if you want to change the value again.
8. Push [PSW1] to write the new value into the EEPROM and shift to adjustment mode standby.
LED1 flashes at 1 sec. intervals, LED2, LED3 go OFF.
Adjustment Range
Adjustment Range Steps Default
±5.0 mm 0.1 mm 0 mm
4. Troubleshooting
340
4