Ricoh BE-C1 D046, Руководство по обслуживанию на месте, Страница: 530 / 734

System Service Mode
SP1000 Feed
1001 Leading Edge Registration
1 1st Roll
Adjusts the printing leading edge registration.
[+10.0 to -10.0/0/0.1 mm]
To delay the starting position of the image, increase the value.
2 2nd Roll
3 3rd Roll/1st Cassette
4 4th Roll/2nd Cassette
5 By-pass feed
1002 Side-to-Side Registration
1 1st Roll
Adjusts the printing side-to-side registration.
[+10.0 to -10.0/0/0.1 mm]
To shift the starting position to the right, increase the value.
2 2nd Roll
3 3rd Roll/1st Cassette
4 4th Roll/2nd Cassette
5 By-pass feed
1003
Registration Buckle Adjustment
Removes skew from sheets feed from the cassettes or paper rolls.
1 Cassette Feed
When the registration sensor detects the leading edge of a cut sheet paper at the nip of the
registration roller, the registration roller motor stops briefly and then starts again.
• This buckles the paper slightly (about 5 mm) to correct skew. Use this SP to adjust the
amount of time that the roller stops.
• Too much buckle can cause wrinkling and lead to poor images. Lower this setting to
shorten the time the registration motor remains off.
• Not enough buckle can cause a jam at the registration roller (lag error). Raise this setting
to lengthen the time registration motor remains off.
[-20 to +20/0/1 mm]
8. Appendix: SP Mode Tables
82
8