Ricoh AP-C3, Руководство по обслуживанию на месте, Страница: 731 / 1334

5804
-31 to -35
Fusing Exit Motor
Note: These SP modes will be moved to Super SP mode in the near future.
Important: Use the procedure below to do the output checks for the fusing exit motor. If
you do not follow this procedure, a kink will form in the fusing belt sleeve, and the fusing
sleeve belt unit will need to be replaced.
1. Do one of the following:
• Open the right cover of the paper bank
• Remove one of the toner bottles
• Pull out the waste toner bottle half-way
• Remove the fusing unit
2. Enter SP mode.
3. Do the following out output checks:
• SP5-804-031 (Fusing exit motor: High speed)
• SP5-804-032 (Fusing exit motor: Middle speed)
• SP5-804-033 (Fusing exit motor: Low speed)
• SP5-804-035 (Fusing exit motor: Very low speed)
4. Without exiting SP mode, turn the main power switch off and then on again.
Important: If you exit SP mode before you turn the main power switch off, the fusing exit
motor will stay off when the machine warms up. Heat will be concentrated in one area
of the fusing belt sleeve and cause a kink to form. If this happens, you will need to
replace the fusing sleeve belt unit.
5. Do the reverse of what you did in step 1 (for example, reattach the fusing unit).
5804 31 Fusing Exit Motor: HighSpeed Fusing/Paper Exit Motor: High Speed
5804 32 Fusing Exit Motor: MiddleSpeed Fusing/Paper Exit Motor: Middle Speed
5804 33 Fusing Exit Motor: LowSpeed Fusing/Paper Exit Motor: Low Speed
5804 35 Fusing Exit Motor: LLowSpeed Fusing/Paper Exit Motor: LLow Speed
ARDF (D630)
6008 Display Description
6008 1 Pick-Up Motor Forward
6008 2 Pick-Up Motor Reverse
Main SP Tables-9
729