Ricoh Aficio 2105, Руководство по эксплуатации, Страница: 39 / 114

33
3. Setting Originals
This chapter explains the procedure for placing originals on the exposure glass
and in the ADF, and setting the original scan area and orientation according to
the placement method.
To correctly display the top/bottom orientation of the scanned original on a
computer, the placement of the original and the settings made on the control
panel and scanner driver must match.
Placing Originals
There are four orientations for placing the original. See the table below.
Note
❒
Normally, an original is or , but in the table below, a square original is
used to make original orientation easy to understand. If the actual shape of
the original is different, the combination of original orientation and the orien-
tation specified on the control panel or scanner driver does not change.
❖
❖ ❖
❖
Specifying Original Orientation and Setting Originals
An original to be scanned
Decide the placement method.
Exposure glass ADF
Place the original.
(There are four original orien-
tations.)
A
Place the
original so that
the top edge
touches the top
left of the expo-
sure glass.
C
Place the
original so that
the top edge
touches the
rear of the ex-
posure glass.
E
Place the
top edge of
the original
first.
G
Place the
original so
that the top
edge touches
the back of
the ADF.
B
Place the
original so that
the bottom
edge touches
the top left of
the exposure
glass.
D
Place the
original so
that the bot-
tom edge
touches the
rear of the ex-
posure glass.
F
Place the
bottom edge
of the origi-
nal first.
H
Place the
original so
that the bot-
tom edge
touches the
back of the
ADF.