Ricoh 161, Руководство по эксплуатации функций, Страница: 50 / 192

Transmission
42
1
Specifying a Destination
This section explains how to specify a destination.
Fax numbers, IP-Fax destinations, and e-mail addresses can be specified.
Note
❒
The display shows the percentage of free memory space for storing originals.
Since fax numbers, IP-Fax destinations and e-mail addresses are programmed
in separate memory, dialing fax numbers using the number keys does not
change the percentage on the display.
Sending Over a Fax Line
Enter numbers directly using the number keys on the right side of the control panel.
A
Press
[ ]
to switch the destination to fax number.
B
Enter the fax number using the number keys.
To specify a destination using a Quick Dial key, see “Using the Quick Dial
Keys”.
If you make a mistake, press the
{
Clear/Stop
}
key, and then enter again.
C
Press the
{
Start
}
key.
The machine starts to scan the original and stores it in memory. When scan-
ning ends, the Communicating indicator lights and transmission starts.
Note
❒
You can insert pauses and tones in a fax number.
❒
For the maximum number of digits for a destination, see “Maximum Values”.
Reference
p.43 “Entering a pause”
p.43 “Entering a tone”
p.53 “Using the Quick Dial Keys”
p.176 “Maximum Values”