Richter KSE 100/150, Инструкция по установке и эксплуатации

Страница: 8 / 34

Series KSE/F, KSE-C/F
Page
8
9530-001-en
Revision 19
TM 9549 Edition 11/2018
♦ The valve must be grounded.
This can be achieved in the simplest way via the
pipe screws using tooth lock washers.
Otherwise grounding must be ensured by different
measures e.g. a cable link.
♦ Plastic-lined valves must not be operated with
carbon disulphide.
4 Safety note for valves, certified to Clean Air Act (TA Luft)
Certificate / Manufacturer Declaration Validity is
dependent on the operating instructions being read
and observed. ♦ Carry out regular maintenance intervals and check
the tightness of the screw connections and tighten
as necessary.
5 Transport, storage and disposal
For all transport work, observe generally
accepted engineering practice and the
accident prevention regulations.
The valve is supplied with flange caps. Do
not remove them until just before installation.
They protect the plastic surfaces against dirt
and mechanical damage.
Handle the goods being transported with care. During
transport protect the valve against impacts and
collisions.
Never transport the valve using the lifting lever
238.
See sectional drawings in Section 10 .
Place valve horizontally on the pallet with the
discharge flange facing down and pad out the box;
transport in this way and deposit gently on a flat
surface.
Directly after receipt of the goods, check the consign-
ment for completeness and any in-transit damage.
Do not damage paint protection.
With the KSE/F and KSE-C/F 100/150 valves, a ring
bolt
900/1 is screwed into the lifting cap 535 which
facilitates transport. It must be ensured that the ring
bolt lies on the axis of the discharge flange so that
equilibrium is guaranteed when the valve is lifted. See
View W in Section 10.4 .
5.1 Transport securing for KSE/F
Safety vales with set pressures ≤ 0.5 bar are fitted at
the works with a transport fastening strap which holds
the stem in the axial direction
and prevents damage to the shut-off element as a
result of the stem shaking during transport. See
Fig. 1
and Section 5.7 .
Fig. 1
Remove the safety wire between the lifting lever 238
and one connection screw 901/1 of the lifting cap 513
/body 100 prior to commissioning .
See Section 6.7 and Fig. 2 .
Fig. 2