INITIAL SET-UP
•
Clip shelves onto dividers, then place dividers in tank
and arrange packs as desired. See illustrations below
for recommendation on how to maximize space for
use with 12 packs.
•
Find drain hose in rear of device. Ensure the valve*
is closed (turned perpendicular to the hose) before
filling the device with water.
FILLING WITH WATER
•
To fill the device, first pour in
3 cups of tap water
, followed
by up to
12 gallons of distilled water
, stopping when the
water level has reached 2” from the top of the tank.
NOTE:
Exact amount of distilled water varies depending
on quantity of packs being used.
NOTE:
Distilled water helps to maintain a clean device,
but doesn’t conduct electricity. For this reason tap water
is needed for the Low Water Sensor to operate properly.
POWERING ON THE DEVICE
•
Ensure power switch on back of device is in the
OFF or O position.
•
Connect the included power plug into the rear of the
device, and then into the nearest available outlet.
•
If using a Deluxe HydraTherm
™, ensure the Heat/Drain
switch on the rear of the device is toggled to HEAT.
•
Toggle the power switch to the ON or I position.
When powered on, the power switch will illuminate, and
the digital display on the front of the device will display
the current water temperature.
Front Rack
3x Univ
ersal
Clip
Clip
2x S
tandar
d
1x S
tandar
d + 1x C
ervical
2x C
ervical
2x Ov
ersiz
e
1x Ov
ersiz
e
*Standard valve is green/blue. Deluxe valve is gray.
Thank you for purchasing the HydraTherm™. This Quick-Start Guide will help you to get started
quickly, but does not replace the Operating Manual. Be sure to read, understand, and practice
the operating instructions, warnings, and cautions included in the manual.
QUICK-START GUIDE
HydraTherm™