Richiger E6910, Руководство оператора

Страница: 30 / 55

923
Emptying the last section of bag
Ending grain extraction
When the bag is to be closed because work has been completed and the unloader is being taken away, sufficient plastic is unrolled, either
hydraulically or by mechanically disengaging the roller, for the bag to be sealed with plastic strips or 2" x 4" boards nailed together.
Whenever grain extraction is ended, either if the unloader will remain with bag attached to continue work later or if it will be towed away,
the correct termination sequence is as follows:
.The roller is brought to a complete standstill by setting valve lever in neutral position or closing flow control knob, in order to stop
the input of grain.
. PTO is left engaged and working for a few minutes so that all loose grain is unloaded, ensuring there is no buildup inside the
discharge auger tube that could be cause of drive overload.
IMPORTANT
When the unloader reaches a point where it can advance no further because the bag is almost finished and the augers are not picking up any
more grain (Fig. 44), it is time to cut short the main operation. After stopping hydraulics and the PTO for reason of safety, the operator should
use a knife to rip open the upper part of the bag, remove stops and lower the machine so that the augers may pick up additional grain (Fig. 45)
while the roller remains stationary. The tractor can engage in some gentle forward and reverse action to boost grain collection. Repeating this
sweeping action, the volume to be loaded by hand can be considerably reduced.