Richiger E6910, Руководство оператора

Страница: 22 / 55

915
15
Fig. 28
14
Set up the blade for work
Mounting the bag
Fig. 31
Fig. 30
Fig. 32
Remove the wing nuts, turn
blade 90° and replace wing
nuts. Then remove blade
guard. (Figs. 28, 29 & 30).
In this way the blade will
face the incoming bag.
Align the machine with the bag opening as
straight and dead center as possible. Open
the bag end and extend it flat on the ground in
an orderly manner. On the approximate mid-
line of the upper half of the plastic make a
lengthwise cut about 3 or 4 meters long. This
cut should reach about the beginning of the
mound of grain. To prevent the cut from
extending further because of grain pressure, it
is a good idea to first determine which will be
the end point of the lengthwise cut and then
proceed to make a short transversal slash
about 10 cm long at this point. Then make the
lengthwise cut starting from this transversal
slash and cutting outward to the bag leading
edge (Fig. 31).
Fig. 29
Spread the flaps outward to leave an opening through which the unloader can introduce
its sweep augers in the bag (Fig. 32).