ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
INTENDED FOR RESIDENTIAL USE ONLY.
TGS66CW
Use the correct bolts as indicated. Do not tighten any of the bolts until the table is completely
assembled.
Do not sit or stand on this table.
A weighted umbrella base must be used when using an umbrella with this table.
Do not discard of any of the packaging until you have checked that you have all of the parts and
fittings required.
Keep children away during assembly. This item contains small parts that can be swallowed by
children. Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
Quote the following FQC NO. when contacting the service center.
SERVICE CENTER TOLL FREE NO.
TEL: 1-877-539-7436
FAX: 1-877-539-7439
PAGE 1 OF 2
V-3
COURTYARD CREATIONS INC.
!
!
!
!
!
!
!
STOP
DON’T RETURN TO STORE!
PARTS LIST
PART
NO.
MATERIAL CODE
PART
Q’TY
1
1
2
3
5
6
7
4
1
2
1
6
TGS66CW-CS05-1
TGS66CW-CS04-1
TGS66CW-CS04-2
62TGS66CWY101
17C17A0403001YX
17KAA0101----Y4
TABLE TOP
LEG
SUPPORT
CENTER
CONNECTOR WITH RING
SCREW ST4.2*12
HEX.KEY WRENCH 4MM
FIGURE 1
2
2
3
3
3
5
5
2
2
1
1
1
2
You will need the following tools:
- Phillips Screwdriver (Not Included)
- Hex. Key Wrench (See Part #7)
Step 1:
Place the table top (#1) onto a non-abrasive surface, such as a
carpet, with its underside facing upwards. Insert the legs (#2)
and the supports (#3) into the plastic holders attached on the
underside of the table top (#1) rim. Fasten them together by
using screws (#5). See Figure 1.
4
6
17C40A0709001YX
BOLT M6*25
