Introduction
©
Rice Lake Weighing Systems
●
All Rights Reserved
1
1.0 Introduction
Manuals and additional resources are available from Rice Lake Weighing Systems at
Warranty information can be found on the website at
1.1 Safety
Safety Signal Definitions:
DANGER: Indicates an imminently hazardous situation that, if not avoided, will result in death or serious injury. Includes
hazards that are exposed when guards are removed.
WARNING: Indicates a potentially hazardous situation that, if not avoided, could result in serious injury or death. Includes
hazards that are exposed when guards are removed.
CAUTION: Indicates a potentially hazardous situation that, if not avoided, could result in minor or moderate injury.
IMPORTANT: Indicates information about procedures that, if not observed, could result in damage to equipment or
corruption to and loss of data.
General Safety
Do not operate or work on this equipment unless this manual has been read and all instructions are understood.
Failure to follow the instructions or heed the warnings could result in injury or death. Contact any Rice Lake
Weighing Systems dealer for replacement manuals.
WARNING
Failure to heed could result in serious injury or death.
Do not use without the enclosure completely assembled and sealed.
Ensure power cord is disconnected from the power outlet before repairing or adjusting the product.
Product must sit on a level, sturdy surface, especially when the cover is open to prevent tipping.
Do not place fingers into slots or possible pinch points.
Use appropriate GFI grounded power outlets for the environment and for use around water.
Product must be installed near an easily accessible power outlet to allow for quick disconnect.
Do not use product if any of the components are cracked.
Danger of explosion if battery is incorrectly replaced. Replace only with the Rice Lake replacement parts.
Dispose of used batteries according to state and local regulations.
Only use product with the designated power supply adapter.
Do not make alterations or modifications to the unit.
IMPORTANT
Please read the following instructions carefully to avoid equipment damage.
Before connecting product to a power outlet, check the voltage of the power source.
Make sure the product is off before plugging the power connector into the power outlet.
It is recommended that the product be connected to a surge protector to prevent possible transient over-voltage damage.
Work inside the product enclosure are to be performed by qualified service personnel only.
