Note
Configuration
© Rice Lake Weighing Systems
●
All Rights Reserved
19
This type of connection allows a SINGLE instrument to be used in a ONE WAY mode.
2.5
SCT20-DN (DeviceNet™) Settings
1. Press and hold
and
.
is displayed.
2. Press or until
is displayed. Press
.
3. Press or until desired parameter is displayed. Press
.
4. Press or until desired value is displayed. Press
.
5. Press
twice to exit set-up menu.
Table 2-9. DeviceNet Parameters
Parameter
Options
Description
*
Set instrument address in the DeviceNet™ network.
*
Set instrument address in the DeviceNet™ network.
* Indicates default value.
2.6
Analog Output
Figure 2-5. Analog Menu Structure
Parameter
Options
Description
Select the analog output type.
for more information.
for more information.
Select the mode to be tracked, gross or net. If the net function is not active, the analog output varies according to gross
weight.
--
Set the weight value for the minimum analog output value.
NOTE: Only set a value different from zero to limit the analog output range.
Example: for a full scale value of 10000 kg, a 4 mA signal at 5000 kg is required, and 20 mA at 10000 kg, in this case,
instead of zero, set 5000 kg.
--
Set the weight value for the maximum analog output value; it must correspond to the value set in the PLC program
(default: calibration full scale).
Example: if using a 4-20 mA output and in the PLC program a 20 mA = 8000 kg is desired, set the parameter to 8000.
Table 2-10. Analog Menu Parameters
),/W(U
3$U$
6(U,$/
W(6W
2XW,Q
$1$/2*
3W$U(
6(W3
&$/,E
P2G(
W<3(
Enter #
X
P$
P$
$Q$
$Q$)6
&2U)6
&2U
Enter #
Enter #
Enter #
Enter #
X
X
*URVV
1HW
Содержание SCT20-AN
Страница 1: ...SCT Weight Transmitter 20 Series Technical Manual PN 131128 Rev F June 26 2018...
Страница 64: ......
