Rice Lake SCT-1100, Техническое руководство

Страница: 41 / 88

Setup Mode 37
4.2.4 Analog Output
Figure 4-4. Analog Output Menu
Table 4-6. Analog Output Parameters
Parameter Settings Description

See Section 6.10 on page 70 for configuring the analog output;
This parameter is not displayed if

is selected;

– selects the slot to be used with the analog output:
•

•


Select the active channel 1-4 in the scale with non dependent channels mode (

/

); The
parameter is not displayed

is set in the

parameter or in a single channel application,







Sets the capacity of the scale;
Enter the capacity set on the primary instrument (000000 to 800000);
The parameter displays only in the secondary mode

Sets the analog operating mode
If the instrument is a primary:
•
 –
analog output disabled.
•

–
analog output on the gross weight
•
 –
analog output on the net weight
If the instrument is a secondary:
•
 –
analog output disabled
•
 –
analog output enabled

Maximum value – Sets the maximum value of the analog output (00000 to 65535)

Scale zero value – Sets the analog output value when the scale is at zero weight (00000 to 65535)

Minimum value – Sets the minimum value of the analog output (00000 to 65535)

Sign – This parameter displays only if the selected operating mode is net weight; In the secondary mode,
functioning on negative weight is not managed
•
 =
Functioning with positive weight.
•

= Functioning with negative weight.
6(WX3
DQRXW
W\SH
PRGH
DRPDK
&KDQ
$R=(U
$R0LQ
6L*Q
$RQR
$RQHW
$R*UR
xxxxxx
xxxxxx
xxxxxx
3R6LW
QH*DW