Rice Lake MSI Dyna-Clamp, Руководство по эксплуатации, Страница: 16 / 20

MSI Dyna-Clamp Tension Meter
12 Visit our website www.RiceLake.com
4.1.1 Error Codes
The ScaleCore processor of the Dyna-Clamp detects errors and generates error codes to aid in troubleshooting.
4.2 Battery Replacement
1. Unscrew the battery cover on the side of the handle.
2. Insert two AA batteries positive end first (can be replaced with rechargeable NiMH cells).
3. Reinstall the battery cover securely.
Figure 4-1. Battery Installation
4.2.1 Disposable Batteries
Low Battery displays when the battery is getting low. When Low Battery starts to blink, the batteries are close to being drained.
For maximum life, use the batteries until the system shuts off.
4.2.2 Rechargeable Batteries
When using Nickel-Metal-Hydride (NiMH) cells, it is recommended that the cells are recharged immediately after Low Battery
starts to blink. Do not allow the batteries to discharge completely, it may compromise the recharge life of the battery.
NiMH Cells have a lower capacity than Alkaline. Having two sets of NiMH batteries is recommended, so one set can be
charging while the other is in use.
The use of NiCad batteries is not recommended.
Remove the batteries prior to storing to prevent possible battery corrosion if the Dyna-Clamp is not going to be
used for an extended period of time.
Error Code Description

LC Disabled – A load cell was not enabled

Not Calibrated – System has not been calibrated


Overload – Tension exceeds set ca8 d;
load Cell damaged or disconnected


Underload – Tension is more than 10% negative;
load cell damaged or disconnected
Table 4-2. Error Codes
Part No. Description Qty
191147 Battery Cap Assembly 1
16431 AA Cell 1.5 V Alkaline Battery 2
Table 4-3. Battery Parts List
AA Batteries
Battery Cover
IMPORTANT