![Rice Lake MSI-4260 IS Скачать руководство пользователя страница 23](http://html1.mh-extra.com/html/rice-lake/msi-4260-is/msi-4260-is_technical-manual_1454180023.webp)
Calibration
© Rice Lake Weighing Systems
●
All Rights Reserved
19
5.2 Standard Calibration
Use the following steps to calibrate the MSI-4260 IS using the standard calibration procedure.
1. Press
,
displays.
2. Press
when the scale becomes motionless. A blinking
displays.
• If the scale is in range
displays, then
displays
3. Load the scale with a test weight (for a single span point calibration, a test weight of more than 20% of capacity or
more is recommended).
4. Press
. The current capacity flashes on the display. If loading the scale with the capacity weight, skip to step 8.
5. Press
if using a calibration weight other than capacity. The far left digit on the display blinks, indicating a
number should be entered.
6. Press
to scroll the numbers and
to enter each digit.
Example: Enter 2500 kg on a 5000 kg capacity scale.
Press
two times for the leftmost blinking digit, press
to save that digit selection.
Press
five times for the next blinking digit, press
to save that digit selection.
Press
to save the next digit selection.
Press
to save the next digit selection.
displays.
7. Press
to save the weight entry. If the cal value is within limits,
is briefly displayed then
.
8. Press
if more cal points are desired or press
if a single point cal is needed.
9. Load the scale with the next test weight and press
if the weight value is acceptable.
10. Press
to scroll through digit selections and press
to enter the calibration weight value.
11. Press
again to complete the calibration span point. If the cal value is within limits,
displays briefly, then
or
displays.
12. Press
to enter an additional span point or
if finished.
’
displays to indicate that the calibration
was successful.
13. Press
.
flashes followed by the
number.
14. Press
to store the calibration.
displays.
15. Press
to exit the calibration menus and start up the standard weight display.
16. Replace the hex seal screw that was removed in
“Calibration Switch Access” on page 18
TARE
T
TARE
T
TARE
T
USER
F
USER
F
TARE
T
USER
F
TARE
T
USER
F
TARE
T
TARE
T
TARE
T
TARE
T
TARE
T
st
ZERO
TARE
T
USER
F
TARE
T
TARE
T
TARE
T
st
ZERO
TARE
T
st
ZERO
st
ZERO