Rice Lake iRev 920i, Руководство по установке, Страница: 90 / 101

86
920i
Installation Manual
Format Identifier Defined By Description
<P[G | N | T]> STR.POS# n
STR.NEG# n
Polarity. Specifies positive or negative polarity for the current or
specified (Gross/Net/Tare) weight on the source scale.
<U[P | S | T]> STR.PRI# n
STR.SEC# n
STR.TER# n
Units. Specifies primary, secondary, or tertiary units for the current or
specified weight on the source scale.
<M[G | N | T]> STR.GROSS# n
STR.NET# n
STR.TARE# n
Mode. Specifies gross, net, or tare weight for the current or
specified weight on the source scale.
<S> STR.MOTION# n
STR.RANGE# n
STR.OK# n
STR.INVALID# n
Status for the source scale. Default values and meanings for each
status:
STR.MOTION#
n M In motion
STR.RANGE# n O Out of range
STR.OK# n <space> OK
STR.INVALID# n I Invalid
<B [–]n,…] See descriptions below Bit fields. Comma-separated sequence of bit field specifiers. Must
not exceed 8 bits.
B0 — Always 0
B1 — Always 1
B2 Configuration =1 if even parity
B3 Dynamic =1 if MODE=NET
B4 Dynamic =1 if COZ
B5 Dynamic =1 if standstill
B6 Dynamic =1 if gross negative
B7 Dynamic =1 if out of range
B8 Dynamic =1 if secondary/tertiary
B9 Dynamic =1 if tare in system
B10 Dynamic =1 if tare is keyed
B11 Dynamic =00 if MODE=GROSS
=01 if MODE=NET
=10 if MODE=TARE
=11 (
not used )
B12 Dynamic =00 if UNITS=PRIMARY
=01 if UNITS=SECONDARY
=10 if UNITS=TERTIARY
=11 (
not used )
B13 Configuration =00 ( not used )
=01 if current DSPDIV=1
=10 if current DSPDIV=2
=11 if current DSPDIV=5
B14 Configuration =00 ( not used )
=01 if primary DSPDIV=1
=10 if primary DSPDIV=2
=11 if primary DSPDIV=5
B15 Configuration =00 ( not used )
=01 if secondary DSPDIV=1
=10 if secondary DSPDIV=2
=11 if secondary DSPDIV=5
Table 10-6. Custom Stream Format IdentiÞers