Rice Lake IQ plus 350, Руководство по установке

Страница: 25 / 48

Configuration 21
3.2.5 Program Menu
Figure 3-9. ProgramMenu
EOLDLY 0
number
End-of-line delay. Sets the delay period, in 0.1-second intervals, from when a formatted line is
terminated to the beginning of the next formatted serial output. Value specified must be in the
range 0-255, in tenths of a second (10 = 1 second).
SERIAL Menu
Parameter Choices Description
Table 3-5. Serial Menu Parameters (Continued)
XXXXXXX XXXXXXX XXXXXXX XXXXXXX
PWRUPM
GO NONE
OIML
REGULA
000000
number
CONSNU
DELAY
VERS ALGOUT DIG IN PROGRM PFORMT SERIAL CALIBR CONFIG FORMAT
000000
number
CONSTU
NTEP
CANADA
PROGRM Menu
Parameter Choices Description
Level 2 submenus
PWRUPM GO
DELAY
Power up mode. In GO mode, the indicator goes into operation immediately after a brief power
up display test.
In DELAY mode, the indicator performs a power up display test, then enters a 30-second
warm up period. If no motion is detected during the warm up period, the indicator becomes
operational when the warm up period ends; if motion is detected, the delay timer is reset and
the warm up period repeated.
REGULA NONE
OIML
NTEP
CANADA
Regulatory mode. Specifies the regulatory agency having jurisdiction over the scale site.
OIML and CANADA modes require the scale load to be at zero before clearing a tare;
OIML mode replaces G (Gross) and Entry Mode annunciators with B (Brutto) and Nicht
Geeicht .
CONSNU 000000
number
Consecutive numbering. Allows sequential numbering for print operations. The consecutive
number value is incremented following each print operation.
The initial value of this parameter is set to the start up value specified on the CONSTU
parameter. Changing either CONSTU or CONSNU immediately resets the consecutive number
used for printing.
CONSTU 000000
number
Consecutive number start up value. Specifies the initial consecutive number (CONSNU) value
used when the indicator is powered on.
Table 3-6. Program Menu Parameters