Rice Lake Challenger 3 MSI-3460, Техническое руководство

Страница: 10 / 46

MSI-3460 Challenger 3
6 Visit our website www.RiceLake.com
3.0 Installation
The MSI-3460 installs easily by hanging it on a crane using properly sized rigging (hooks, shackles, slings).
Refer to the Crane Scale Safety and Periodic Maintenance Manual (PN 153105) for safe loading and rigging
guidelines when installing the model MSI-3460.
Regular maintenance inspections of the lifting system should be performed to ensure safety. Pay particular
attention for signs of stress on any element in the load train.
Use the appropriate interface hardware for the capacity and design of the scale.
• Rice Lake Weighing Systems can supply the MSI-3460 with oversize lifting eyes or shackle interfaces if the interface
hardware does not fit properly.
• Install the scale using adaptive rigging if the crane hook is too large to fit in the lifting eye with single point interface.
• If multiple attachments are needed, use a shackle or ring to attach the multiple lines to keep a single point attachment to
the scale.
Using an oversize shackle or hook to interface with the MSI-3460 can cause off center loading and stress points
that will reduce the life of the lifting eye or hook.
Single point attachments are necessary to ensure the safety and accuracy of the scale system.
3.1 Unpacking
Ensure that all assembly parts are accounted for when unpacking the scale from the shipping container. Check the scale for
any visible damage and immediately report any damage to the shipper. Rice Lake Weighing Systems recommends using the
original shipping container when shipping or transporting the MSI-3460 .
3.2 Assembly
Figure 3-1. MSI-3460 Assembly
1. Slide the hook clevis over the load cell with the open end of the hook toward front of the scale.
2. Align the holes of clevis and load cell.
3. Slide the clevis pin through the clevis and load cell holes.
4. Lock the clevis pin in place with a cotter pin. Bend the cotter pin.
The scale will be unsafe for use if the clevis pin is not properly secured with the cotter pin.
5. Slide the battery pack into the battery compartment. The battery will automatically engage with its connectors.
6. Secure the battery pack by turning the two locking fasteners on the access door clockwise 1/4 turn.
WARNING
IMPORTANT
Battery
Cotter
Load
Hook Clevis
Clevis
WARNING