RHINO RAMV2, Инструкция по эксплуатации, Страница: 26 / 40

26
3.3. Remote Control Programmable Features
Your Rhino Security system incorporates the latest in high security features. It is
possible to customise your security system so that it suits your requirements perfectly.
Detailed below is the full list of programmable features that can either be turned on or
turned off.
We have set at the factory the most common configuration chosen and these settings are
listed in the REGISTER Settings listed below. Once the desired features have been
selected, the selection is permanently retained in memory, even if power is removed, or
the override key switch is turned to off. This includes the Past Alarm Trigger Memory.
To turn on or turn off any feature use the following procedure: eg to disable passive
arming.
1.
Find the REGISTER (1, 2 or 3) in which the feature is located. (Eg: passive arming is
located in REGISTER 1).
2.
Set the vehicle up as described to access REGISTER 1, (doors closed, bonnet closed,
turning the ignition on last).
3.
Press the remote control button an equal number of times to the selected feature’s
code number (eg 5 times for passive arming).
4. Turn the ignition to off.
5. The system will then confirm which features are activated via audible readout. If a
feature is enabled the siren will chirp out its
code in beeps from the siren corresponding
to the number shown in the column “ Press Remote This Many Times ”. The siren in
this example will beep in order Once, then Twice, etc. up to Eight times. The system
misses the passive arming code of 5 Beeps as this feature has been disabled.
Please note
that feature 9 is excluded from the confirming number of beeps on all 3 Registers.