RHINO RAMV2, Инструкция по эксплуатации

Страница: 18 / 40

18
2.8.3. Emergency Panic
BY SMS BY REMOTE CONTROL
PANIC: Type your PIN number and
PANIC from a mobile phone, and send
it to the alarm. Once the message is sent
the alarm will go into
“PANIC ALERT.”
This will sets off the siren and sends an
SMS message to
ALL phone numbers
alerting them that panic is activated.
(WHERE 123456 = YOUR PIN NUMBER)
The reply message below will be sent to
all mobile phone numbers.
PANIC ALERT!
If the cars ignition is on, the alarm
will NOT go into PANIC mode and
you will not receive an SMS
response.
To SET the alarm into “ PANIC mode” ,
press the Right button. This will sets off
the siren & blinkers, and sends an SMS
message to all phone numbers alerting
them that the alarm is in “PANIC
ALERT.”
To
CANCEL “PANIC ALERT” press the
same button again on the remote control.
You can also cancel the “PANIC ALERT”
by press the Arm/Disarm button.
NOTE:
Panic does not work when the ignition is
turned on by requirement of Australian
Law.
(EPA - Environmental Protection Agency)
2.8.4. System Status Report
STATUS: Type your PIN number and STATUS from a mobile phone, and send it to
your alarm and you will receive the alarm systems current status.
(WHERE 123456 = IS YOUR PIN NUMBER)
The SMS message that you will receive
back will inform you of:
ALARM on/off.
Phone Signal good/bad.
Car Battery good/low
123456PANIC
123456STATUS
123456PANIC
123456STATUS