Rhino-Rack SUNSEEKER II Awning 2.0 metres (32109)
Important:
Please read these instructions carefully prior to installation.
Please refer to your fitting instruction to ensure that the roof racks are installed in the correct locations.
Check the contents of kit before commencing fitment and report any discrepancies.
Place these instructions in the vehicle’s glove box after installation is complete.
Important Information
Recommendations
It is essential that all bolt connections be checked after driving a short distance when you first install your Rhino
SUNSEEKER II Awning. Bolt connections should be checked again at regular intervals (probably once a week
is enough, depending on road conditions, usage, loads and distances travelled). You should also check the
roof bars each time they are refitted.
Use only non-stretch fastening ropes or straps.
Please remove SUNSEEKER II Awning and crossbars when putting vehicle through an automatic car wash.
Load Ratings
With the addition of the SUNSEEKER II Awning, the load capacity of your crossbars will have to be adjusted
accordingly. The SUNSEEKER II Awning and 2 crossbars weigh approximately 15kg.
Note for Dealers and Fitters
It is your responsibility to ensure this fitting instruction is given to the end user or client
Layout
Note: Use caution in windy
conditions! The pegs and ropes
must always be used when the
SUNSEEKER II awning is open.
Page 1 of 13
