983001 8370 EWC8370 8318 Issue May 2007
Page
16
5) Calendar Binding (HC-8318 only):
The HC 8318 Wire Inserter can bind books up to18” (457MM) long or documents
with a calendar hanger inserted into the two wire elements. When binding any
continuous wire up to 18” long, use the prior instructions for binding a book. All
setup instructions are the same for the 18” version except where listed below.
Books will have to be punched with a thumb cut style die that have two loops
missing where the thumb cut is placed. The pitch has to remain continuous from
the first to the last hole.
Binding a document with a calendar hanger: The calendar hanger will always
be placed in the center of the machine into the wire elements. The two wire
elements will be placed to the left and the right of the hanger.
¾
There is a label on the table specifying the placement of the hanger that is
located at the centerline of the machine. On each side of the hanger label
are single book stops. Place the left element so the loop on the extreme
right side is placed on the right side of the book stop. Now place the right
elements extreme left loop over the left side of the book stop.
¾
Place the hanger between both wire elements. Make sure hanger falls into
slot on table.
¾
Rotate the Upper Wire Guide down. Magnets will hold the wire elements
firmly in place while inserting calendar.
¾
Place the calendar into the opening with covers down. Make sure it is all
the way in against book stops and to the left against the book guide.
¾
Pull the handle all the way down to close the wire.
¾
Place the handle to its full open position.
¾
Remove document and check close.
