983001 8370 EWC8370 8318 Issue May 2007
Page
14
STEP 8, Adjust Book Guide:
Locate the book guide adjustment knob in Figure 8b item 1 only located on
the left side of the machine. Unlock the center winged knob and turn the
outside dial until the book guide indicator is in front of the book length to be
bound. Fine tune while the Book is aligned to the Book Guide (2) and the
punched holes align with the Wire (3). See Figure 8c. If overhanging covers
are to be used (4), offset of book to cover can be obtained by loosening the
overhanging cover guide knob (5) and offsetting the contents of book to cover
with the Covers under the Overhanging Cover Guide (6). The alignment of the
Cover Holes and Book Holes (7) to the wire will have to be done manually
when using overhanging covers. Retighten when adjusted.
Hint: The book guide will have to be adjusted manually if the book is not a
standard size or if overhanging covers are used. To do this, make sure all
other adjustments are made and a wire is in its loaded position. Simply lift
up the upper wire guide away from the book table and line the holes of the
book laterally to the upper, narrow loops of the wire. Adjust book guide to
edge of book.
Fig. 8b
