Rheem 340SS, Руководство пользователя и инструкции по установке, Страница: 30 / 52

INSTALLATION
30
WALL BRACKET
It is recommended to secure the water heater to the wall. The top of the unit is
to be secured to the wall (or screen) using the wall bracket provided. Use the
M6.5 masonry anchor provided only if it is suitable for the wall type. Otherwise
select and use an alternative fastener suitable for the application.
The fastener must be capable of bearing the weight of the water heater so it may
neither work loose, pull away from the wall nor impose any load on the gas and
water pipe work connected to the water heater. Refer to the fastener
manufacturer’s information and recommendations for the type of fastener to use
for the wall type and load bearing requirements.
To fit the wall bracket:
• Slide the wall bracket into the
formed slot at the top rear of the
water heater.
Ensure the angled profile is
facing the wall.
• Mark the wall where the hole is to
be drilled.
•
Remove the bracket.
•
Drill the hole to receive the
M6.5 masonry anchor or other
suitable fastener.
• Replace the wall bracket with the
angled profile facing the wall.
• Secure the wall bracket to the
wall.
masonry
anchor
wall
bracket
bracket
slot
nut