Manual CE (SAGOMA_GB)
Sezione 12 Part 12. Programming of the machine
12.1 Memory
The machine is controlled by a programme stored in the
microprocessor of the FLASH memory, installed on the CPU board.
The program stored in the memory can be updated with a FLASH
serial card or with a serial cable.
At the switching on of the machine a mssage will display the latest
version iof the software loaded into the machine.
12.2 Factory set parameters
The machine is supplied already pre-set for the most common operation parameters. In particular:
- configuration of the version;
- throw of coffee, powdered ingredients, tea and quantity of water required;
- vend prices (set to 0: the machine is in the free vend mode);
- pre-setting for the use of the system of parallel payment;
- the clock function disabled;
The programming of the machine must be modified only if the pre-set factory parameters are not
complying with the required use.
12.3 How to enter and exit from the programming mode
To modify the operation parameters of the machine it is necessary to enter in the programming
mode.
To enter press the
key PROG
inside the machine on the CPU protection.
The display shows:
PROGRAMMING - - -
- - - - - - - - - - - - - - - - -
Pressing
button 1
the display shows:
PROGRAMMING - - -
BUTTON 1 - - - - - - - -
Once the parameters have been modified, press again the
key
PROG
inside the machine on the
CPU protection.
FREE
The display shows:
27/27
