Manual CE (SAGOMA _GB)
Remove the board prism positioned
between the canisters of the
ingredients and the top of the
cabinet.
Sezione 8
Part 8. Positioning
The machine must be installed indoor on a flat and sound floor. If the machine is installed in a
safety gangway, the remaining opening of passage between the machine with the open door and
the nearest obstacle must be at least 80 cm.
Anchor the machine to the rear wall as follows:
- loosen the two screws which lock the fixing bracket on the machine cover;
- turn the bracket by 180° and fit it again to the machine by means of the appropriate
screws
previously removed;
- move the machine near the wall until the bracket rests against the wall;
- regulate the feet placed under the machine for a correct levelling: there must be less than 2°
offset of the machine vertical axis with respect to the vertical axis of
the wall;
- drill the wall with a diameter 8 mm pin, using the bracket as drilling
template;
- fix the bracket to the wall by means of the screw anchors supplied in
the waste disposal bucket.
M.P.R. declines all responsibility for any shortcomings caused
by non compliance with installation instructions.
If the machine is installed on delicate or valuable floors, it is advised
to lay a carpet under the machine, about 80 cm larger than the
machine itself, made of rugged material, resistant to dirt and water
(e.g. synthetic laminate). This is to protect the floor and also prevent
it to get dirty for the accidental spilling of beverages.
A schematic general lay-out is indicated in the figure.
14/14
