1960s CANISTER TASK TABLE LAMP WITH WIRELESS CHARGING - ASSEMBLY INSTRUCTIONS
PARTS ENCLOSED:
(A) Lamp shade (1)
(B) Arm handle (1)
(C) Lamp base (1)
(D) ON/OFF rotating knob
(E) Plug
(F) Arm knob (1)
(G) Shade joint (1)
(H) LED bulb (1)
(I)
Charging pad (1)
IMPORTANT SAFETY INSTRUCTIONS:
For safety purposes, this lamp is equipped with a polarized plug (one blade is
wider than the other). If the plug does not fit securely into your outlet, do not force
it - contact a professional electrician. Use the plug with an extension cord only if it
can be fully inserted into the cord's socket. Never alter the plug in any way.
This lamp has been rated for up to (1) 5w max LED bulb (included); only an LED
bulb can be used. To avoid the risk of fire, do not exceed the recommended
wattage.
WARNINGS:
All wires are connected. When unpacking, be careful not to pull wires, as a bad
connection may result. Do not connect electricity until your lamp is fully
assembled. To reduce the risk of fire, electrical shock, or personal injury, always
turn off the lamp and allow it to cool prior to replacing the lightbulb. Do not touch
bulb when lamp is turned on or look directly at lit bulb. Keep flammable materials
away from lit bulb.
THIS PRODUCT IS NOT A TOY AND HAS NO PLAY VALUE.
WARNING: STRANGULATION HAZARD
Keep cord at least 3 feet away from cribs, bassinets, and
toddler beds. Keep out of reach of children under 3 years of age.
ASSEMBLY & INSTALLATION:
1. Carefully remove all parts from the box and remove plastic coverings.
2. Carefully place the lamp base (C) on a tabletop.
3. Adjust the lamp shade (A) with shade joint (G) using arm knob (F) and arm
handle (B) to get the desired angle and height. Follow the steps below to adjust
the knob.
A. To adjust the position of the arm, lift up the arm handle to loosen the arm knob.
B. Loosen the arm knob and adjust the arm to the desired angle, then tighten the
knob. You don't need to lock the knob with much force; just push the arm
handle down a little to hold the lamp in position.
4. Insert the LED bulb (H) into the socket and turn to tighten.
5. Insert plug (E) into proper electrical outlet and test the lamp.
6. Turn the rotating on-off switch (D) on the base to turn the light on or off.
7. Place your cell phone on the charging pad (I) to charge as needed.
8. Assembly is complete.
CARE INSTRUCTIONS:
Do not use polishes or cleaners, as they may damage the finish.
Wipe clean with a soft, dry cloth.
1960s CANISTER TASK TABLE LAMP WITH
WIRELESS CHARGING
