Page 10 of 10
STEP #5
TODDLER RAIL ASSEMBLY
STEP #5.1:
Remove the front rail panel of the crib by loosening all the bolts
installed.
STEP #5.2:
Gently tilt the crib and release the bolts underneath the metal
brackets holding the stabilizer rails.
STEP #5.3
Gently remove the mattress support and slightly loosen the bolt
at the back of the headboard that enough to set the toddler rail
in-between side rail panel.
NOTE
: Fill the holes located on the top of both side rail panel by
inserting bolt (Ø1/4x1/2") provided. See
Detail
G.
STEP #5.4
On inside face of both side rail panels there is a cavity for the
hooks, which corresponds to the hooks on both ends of the
toddler rail. Align and insert the hooks of the toddler rail into the
cavity of the side rail panel. See
Detail H.
-
NOTE:
If mattress support is not in the lowest position, unscrew
mattress support bolts and move the lowest position.
STEP #5.5
Repeat step #3. Installation of stabilizer rails into the side panel
(
DETAIL E).
After assembly, re-tighten all bolts to a snug fit.
DETAIL H
H
G
DETAIL G
ALLEN BOLT
Ø1/4" X 1/2"
DETAIL E
HARDWARE FOR STEP #5
1/4" X 1/2" BOLT = 2 PCS
