© Xiamen RGBlink Science & Technology Co., Ltd.
Ph: +86 592 5771197
| [email protected] | www.rgblink.com
17
3.2 Remote Controller
3.2.1 Keys Instruction
1. Standby Key
After 3S long press, the camera will step into standby mode. Long press 3S again,
the camera will
self-test again and back to HOME position. (Note: If power-on mode is turned on
and Preset 0 is
set, and there is no operation within 12s, it will automatically point to the
specified preset position.
2. Camera Selection
Select the camera address which wants to be controlled
3. Number Key
Set or run 0-9 presets
4. *,# Key
Key combination use
5. Focus Control Key
Auto Focus: Enter into auto focus mode.
Manual Focus: The camera focus mode is manual
Switch the camera focus mode to manual focus by pressing [focus +] or [focus -] to
adjust
6. Zoom Control Key
Zoom
＋
:Lens near
Zoom
－
:Lens far
7. Set or Clear Preset key
Set Preset: Set preset key + 0-9 number key:
Clear Preset key: Clear preset key + 0-9 number key
8. Pan/Tilt Control Key
Press Key :Up
Press Key :Down
Press Key :Left
Press Key: Right
“HOME” Key: Return to the middle position or enter into the next level menu
9. BLC Control Key
Back Light ON / OFF: Turn on or off the back light
10. Menu Setting
Open or close the OSD menu
Enter / exit the OSD menu or return to the previous menu
11. Camera IR Remote Control Address Setting
