RF Technology Safe Place Patient, Руководство пользователя

Страница: 21 / 40

General Information
Safe Place Transmitters User Guide Page 19 of 36
0510-1121-G
8. Use safety scissors to cut off the excess
banding material. Try not to cut bands
too short to allow room to adjust in
future.
Patient
(Locking)
To band a patient transmitter:
1. Cut off 6-8” of the banding material from
the roll.
2. Verify that the transmitter is unlocked.
See the “Unlock a Transmitter” section
for further details.
3. Open the clamps of the transmitter by
gently pulling them outward, one clamp
at a time, from the top of the transmitter.
4. Insert the banding material through the
slot on the non-locking clamp side of the
patient transmitter, from bottom to top,
with the white side facing out.