REXROTH MAD100, Руководство по эксплуатации

Страница: 43 / 70

① O-ring position
Fig.6-10: O-ring at the screwed cable gland
⇒ Before attaching the adapter plate to the power cable, visually check
the O-ring at the screwed power cable gland for proper condition and
correct position. If the O-ring is missing, do not use the power cable. In
this case, contact your Rexroth sales or service partner.
6. Place the power cable through the opening into the terminal box up to
the adapter plate. Reattach the adapter plate to the terminal box.
Screw tightening torque ⑥: 9 Nm (±10 %)
⇒ Before attaching the adapter plate ⑥ to the terminal box, check the
O-ring ⑤ inserted in the adapter plate for proper condition and correct
position.
7. Connect the wires in accordance to the connection diagram for standard
or double cabling.
Observe the following tightening torques:
Tightening torque of the screws in Nm (±10 %) for power connec‐
tion
Terminal box on
U-V-W PE
M6 M12 M8 M12
MAD/MAF100 ...
160
2.5 - / - 3.5 - / -
MAD/MAF180 ...
225
- / - 14 - / - 20
Fig.6-11: Tightening torque for screws in Nm in the terminal box
8. Close and attach the cover of the terminal box.
Moisten the thread of the mounting screws for the cover ① with liquid
threadlocker. Then attach the cover using all of the mounting screws.
Tightening torque of the screws: 6.5 Nm (±10 %)
⇒ Before attaching the cover to the terminal box, check the glued-in seal
② on the terminal box cover for proper condition and correct position.
Double cabling Motor connection with two power cables is required if a corresponding single
cable cannot be used due to the large bending radius or due to its dimen‐
sions.
DOK-MOTOR*-MAD/MAF****-IT01-EN-P
Rexroth IndraDyn A Asynchronous Motors MAD / MAF Bosch Rexroth AG 41/67
Assembly