REXON DP3800RF, Инструкция по эксплуатации, Страница: 8 / 24

5
the column as far as possible. Align the
head with the base.
2. Using the 5 mm hex wrench, tighten the
two head lock set screws (3) on the right
side of the head.
INSTALLING FEED HANDLES (FIG. 6)
1. Locate the three feed handles (1) in the
loose parts bag.
2. Screw the three feed handles (1) into the
threaded holes (2) on either the right or
left side hub assembly (3) and tighten.
NOTE:
The feed handles can be installed
on either the right-hand side or left-hand
side.
INSTALLING THE CHUCK (FIG. 7, 8, 9)
1. Push the chuck (1) onto the spindle
arbor (2). Tap gently on the arbor with
a hammer or rubber mallet to ensure a
proper seat.
2. Lower the spindle by turning the feed
handles (3) counterclockwise, until the
slot (4) appears on the quill (5).
3. Push the chuck and spindle arbor up
into the spindle, making sure the tang
(6) (upper narrow end of the spindle
arbor shank) is engaged and locked in
the inner slot (7) of the spindle. This
can be seen through the outer slot (4) of
the quill by rotating the chuck and arbor
until the two slots are aligned.
4. Open the jaws of the chuck (1) by
rotating the chuck sleeve clockwise. To
prevent damage, make sure the jaws
are completely receded into the chuck.
NOTE:
Clean the taper with a non-alcohol
based cleaner before inserting it into the
arbor.
WARNING! Before any assembly of the
chuck and arbor to the drill press head,
clean all mating surfaces with a non
petroleum based product; such as alcohol
or lacquer thinner. Any oil or grease used in
the packing of these parts must be removed
otherwise the chuck may come loose during
operation.
5. Using a rubber mallet, or a hammer and
a block of wood, firmly tap the chuck
upward into position on the spindle
shaft.
CHUCK KEY STORAGE (FIG. 10)
Storage holder (1) for the chuck key (2) is
located on the right side of the drill press.
INSTALLING THE BULB (FIG. 11)
NOTE:
Bulb is not included.
1. Install a light bulb (1) (no larger than 40
watt) into the socket
.
ADJUSTMENTS INSTRUCTIONS
NOTE:
All the adjustments for the operation
of the drill press have been completed at
the factory. Due to normal wear and use,
some occasional readjustments may be
necessary.
BEVEL DRILLING (FIG. 12)
NOTE: A bevel scale has been included
to measure approximate bevel angles. If
precision is necessary, a square or other
measuring tool should be used to position
the table. To use the bevel scale (6).
WARNING!
• For your own safety, never connect plug
to power source outlet until all assembly
steps are complete and you have read
and understood the safety and operating
instructions.
• To prevent injury resulting from heat of
the light bulb. Never touch the light bulb.
• To prevent electric shock. Never touch
the bulb socket when the plug from the
power source is connected.
WARNING! To avoid injury from an
accidental start, ALWAYS make sure
the switch is in the “OFF” position, the
switch key is removed, and the plug is not
connected to the power source outlet before
making adjustments.
Setting the Tool