REXON DP3800RF, Инструкция по эксплуатации, Страница: 7 / 24

4
Specifications
NOTE: Move all parts to
the desired work site before
assembling them together. Follow
the assembly instruction and
carefully assemble the tool with the help of
a second person.
ITEM
Motor (rated input)
625W, 220V~,
60Hz
Speed (min
-1
) 12 (250-3100)
Chuck capacity (mm) Ø16
Max. Drilling (mm) Ø22
Spindle taper MT2
Arbor
MT2, JT3
Weight (kg) 68.6
Size of table (mm) 336 x 336
Size of base (mm) 518 x 279
Spindle travel (mm) 102
Column diameter (mm) Ø73
Distance from chuck to
column (mm)
190
Distance from chuck to
base (mm)
1,127
Overall height (mm) 1,625
WARNING!
• For your own safety, never connect plug
to power source outlet until all assembly
steps are complete and you have read
and understood the safety and operating
instructions.
• The drill press is a heavy power tool
and should be lifted with the help of two
people OR MORE to safely assemble it.
Assembly
ASSEMBLING COLUMN TO BASE
(FIG. 2)
1. Position the base (2) on a flat work
surface.
2. Place the column (1) on the base,
aligning the mounting holes to the base.
3. Locate the four hex bolts (3) from the
loose parts bag.
4. Place a bolt in each hole through the
column support and thread into the
base. Tighten with a wrench.
INSTALLING THE TABLE (FIG. 3, 4)
1. Locate the table crank handle (1) and
support lock handle (2) from the loose
parts bag.
2. Insert the support lock handle from the
left to right into the hole (3) at the rear of
the table support assembly. Tighten by
hand.
3. Install the table crank handle (1) onto
the small shaft (4), aligning the set
screw (5) with the flat surface of the
shaft (4). Tighten the set screw with a 3
mm hex wrench.
4. Loosen the support lock handle(2).
Raise the table arm assembly by turning
the crank handle (1) clockwise. Tighten
the support lock. (Fig. 3)
5. Insert the table lock handle (7) from the
right to the left into the hole at the front
of the table support assembly.
6. Place the table (6) in the table arm
assembly. Tighten the table lock handle
(7) by hand. (Fig. 3)
NOTE: Check the rack ring (8) to make
sure it is tight. If not, tighten with the 3 mm
hex wrench.
INSTALLING THE HEAD (FIG. 5)
1. Carefully lift the head (1) above the
column (2) and slide it onto the column.
Make sure the head slides down over
WARNING! To avoid injury, disconnect the
plug from the power source before
performing any adjustments or repair.