Domestic axial fan with throttle
CODE Series
User Manual
Introduction
Thank you for choosing our product. Reading of this manual
is required for proper use of the device and absolute
observance to its guidelines is fundamental condition
of security.
All users of the device should have free access
to the manual and in case of resale, the instruction must
be attached to the product.
Package contents
- domestic axial fan CODE
- user manual
Transport and storage
The fan should be transported and stored in the original
packaging in a dry place protected from contamination,
until it is installed. Moreover, the fan should be protected
from the shocks.
Application
Axial fans from the CODE series are designed for wall
mounting. They are used for ventilation of small spaces
such as a bathroom or kitchen.
The device in white color version.
Construction of the device
1
–
Panel
2
–
Sensor Cover
3
–
Sealing
4
–
Sensor/Timer 5
–
Base
6
–
Motor
7
–
Rotor
8
–
Throttle frame 9
–
Throttle
10
–
Fastening ring 11
–
Frame
12
–
Screws
13
–
Wire terminal 14
–
Switch 15 - Diode
Dimensions (in mm)
MODEL
ØA
B
C
D
CODE 100
98
157
60
21
CODE 120
118
157
65
21
CODE 150
148
200
76
21
Technical data
MODEL
CODE 100
CODE 120
CODE 150
Maximum aiflow [m
3
/h]
130
240
320
Maximum compression [Pa]
36
45
60
Voltage [V]/Frequency [Hz]
230/50-60
230/50-60
230/50-60
Rated current [A]
0,072
0,11
0,138
Engine speed [rpm]
2400
2200
2000
Engine power [W]
12
16
18
IP protection degree [-]
X2
X2
X2
Noize [dB(A)]
34
34
35
Installation instructions
In order to accomplish the installation of the device
successfully and enable the safe usage of the fan
in the future, it is essential to follow the instructions in this
manual.
Before installing and connecting the fan, check that it has
not been damaged during transport or storage (breakage,
distortion).
Check whether the technical data on the nameplate
corresponds to the electrical installation parameters.
The device should be mounted on a flat surface.
If irregularities are not found, you can proceed
with the installation as follows:
- prepare appropriate electrical wires
- mark the location of mounting holes
- drill the holes and put expansion bolts in them
- place the fan in the right place and tighten screw it
- connect the device to electrical grid
The electrical connection must be in accordance
with the wiring diagram in the terminal box.
Warnings and precautions
During the operation of the device, the following
precautions must be observed:
- before performing any work, the device must
be disconnected from the power supply
- the fan is intended only for ventilation of rooms with small
and medium cubature
- installation height of the exhaust fan min. 2.3 m
- do not connect the fan to the ceiling
- avoid backflow of air through the chimney
