NOTE:
All of the parts shown in the following illustrations are supplied
with the M-Stands.
1. Attach the stand base to the stand riser as shown in the illustration below.
Large
Allen Wrench
Black M6 x 50mm
Fine-Thread Bolt
Washer
2. Spin the clamping rings onto the spikes and insert the spikes into the bases
as shown in the illustration below. You can install the spikes with either the
pointed end or rounded end protruding from the base.
Rounded end out
(wood or tile floors)
Pointed end out
(carpeted floors)
Spike and
Locking Ring
Washer
s)FTHESTANDSARETOBEPLACEDONACARPETEDmOORINSTALLTHESPIKESWITHTHE
pointed ends protruding from the stand base.
s)FTHESTANDSARETOBEPLACEDONAWOODORTILEmOORINSTALLTHESPIKESWITH
the round ends protruding from the stand base.
After determining the final locations for the speakers you can place coins under
THESPIKESTOPROTECTTHEmOORSURFACEFROMDAMAGE
NOTE:
)FYOUWISHYOUCANINSTALLTHESPIKESWITHTHEPOINTEDENDS
PROTRUDINGFROMTHESTANDSFORPLACEMENTONWOODORTILEmOORS)NTHIS
case you must place coins or similar items under the spikes to avoid
DAMAGINGTHEmOORSURFACE
Rotate the locking ring clockwise to firmly secure the spike to the cabinet.
Make sure to thread the locking rings of all four spikes to achieve a level
BALANCEWHENTHESTANDISPLACEDRIGHTSIDEUPONTHEmOOR
3. Attach the stand top to the stand riser as shown in the illustration below.
Large
Allen Wrench
Black M6 x 30mm
Fine-Thread Bolt
Washer
4. Attach the speaker to the stand as shown in the illustration below. Only
Revel Performa3 M106 and M105 speakers can be attached to the M-Stand.
Use the VELCRO
®
strap on the rear of the stand for wire management.
Small
Allen Wrench
3/4" 1/4 x 20
Coarse-Thread Bolt
Washer
M Stand Assembly Instructions