REVBOX Erg Owners Manual
Introduction
Congratulations on the purchase of your new Revbox Erg – a low inertia stationary air resistance
trainer with no flywheel assistance; designed, developed and assembled in New Zealand.
The Revbox will make you stronger and more efficient as it recruits and engages all the muscle
groups throughout your pedal stroke, increasing strength and neuromuscular efficiency, and fo-
cuses your pedaling technique.
Welcome to the Revbox Community!
In the Box
Your Revbox Erg should come with the following:
1 x Revbox trainer unit
1 x Stabiliser leg
1 x Short quick release skewer for the stabilizer leg
1 x Long quick release skewer to mount the bike
1 x Velcro fastened carry handle which can/should be removed if not required
1 x 0.7mm cassette spacer
The following optional parts are also available:
Miche 10 speed cassettes different ratios (Shimano Compatible) (Different Ratios Available)
Revbox soft carry bags
Revbox foam carry bag for international travel
To purchase any of these see: http://www.revbox.co.nz/shop
Set-Up
To prepare your Revbox Erg for use, please set it up as follows:
1. Take your new trainer unit and stabiliser leg out of the box.
2. Fit the short quick release skewer to lower front of Revbox unit.
3. Attach the stabilizer leg to the Revbox unit using this short quick release skewer – make
sure the leg is pushed in as far as possible, so there is almost no gap
(See Image 1)
between the
leg and the unit, and the guide plates are resting on the stops
(See Image 2)
, then tighten the
skewer as tight as possible to fix the stabiliser leg securely in place.
