INSTALLATION WARNINGS:
BEFORE COMMENCING INSTALLATION ISOLATE YOUR MAINS ELECTRIC SUPPLY
Read the instructions care fully before starting the installation process and keep them for future reference. This product must be
installed by a qualified electrician.
This product should be installed in accordance with the relevant sections of the building regulations
code, and the current edition of the IEE Wiring Regulations (BS 7671:Requirements for electrical installations) and appropriate
statutory regulations.
Installation
THIS WIREFREE SWITCH
MUST BE USED IN
CONJUNCTION WITH A
RTS2020 OR RTS2040
WIRED TOUCH AND
REMOTE SWITCH.
Remove the glass panel
of a touch remote switch: Using
a small flat screwdriver remove the front cover by placing the
screw driver in the location notch on the bottom part of the
cover and twist to unclip the cover.
Wiring:
Wire the wired switchas described in there
instructions. remember to push wires firmly into terminals and
tighten terminal screws so that wires are held securely. No bare
wires should protrude from the terminals. Ensure correct wires
are connect to the correct terminals, if incorrectly wired, this
could damage the switch.
Fix screws:
Use the screws supplied to attach switch to
backbox using a flat head screwdriver
Reattach the glass panel:
Align the glass panel over the
switch and firmly push to click into place.
Pairing the switch
The wireless switch is
remotley syncing to the
master switch which is
wired. This wired switch
can sync to up to 4 wire-
less switches or remote
controls at any one time.
Pairing a wirefree switch
1. turn on the light then touch & hold
the on/off touch area of the master
switch for 5 seconds and wait for the
beep.
2. Press and hold a touch area on the
wireless switch control and release after
you hear a beep. The switch is now
paired. Repeat for all gangs you required paired.
Power on:
Once paired,touch the panel it will only
illuminate when pressed as running on 9V battery power.
Un-registering a remote:
Repeat steps for registering the remote. When pressing and
holding the remote button, wait for two beeps and the
remote will be un-paired.
Factory reset:
Press and hold the switch for 5 seconds
till you hear a beep, continue to hold for a further 8
seconds until you hear another beep. The switch is now
back to factory settings.
twist to remove
75 3mm
60mm
7
5
3
m
m
RTS2020W
RTS2040W
For support visit www.retrotouch.com/support
lock here
first
Push
until click
Master switch
Wireless switch
Wirefree light switch instruction manual
