1.
Turn on your Clip-On
Microphone by sliding the
ON/OFF switch down to
the ON position.
2.
Open the battery doors
on both hearing instru-
ments.
3.
Remove the cover from
the Clip-On Microphone.
Press the pairing button
once to put the Clip-On
Microphone in pairing
mode for 20 seconds.
PAIR WITH YOUR HEARING INSTRUMENTS
LISTENING TO SOUND FROM YOUR
CLIP-ON MICROPHONE
1.
Plug one end of the
charging cable into the
Clip-On Microphone.
2.
Plug the other end of
the charging cable into
a power outlet.
3.
Generally, charging is
complete when the red
LED indicator turns solid
green interrupted by a red
blink every 2 seconds.
However, when charging
for the first time allow it
to charge for at least 3
hours, even if the battery
indicator indicates that the
battery is fully charged.
4.
The LED indicator will
now blink yellow once
every 2 seconds to indi-
cate that it is ready to be
paired in channel 1.
5.
While in pairing mode
close the battery doors
on both hearing instru-
ments.
6.
Successful pairing
will be indicated by an
audible melody played in
both hearing instruments.
Replace the cover on
the Clip-On Microphone
once pairing is complete.
CHARGE YOUR CLIP-ON MICROPHONE
Turn on the Clip-On Micro-
phone and make sure your
hearing instruments are
turned on. Streaming may
be started in one of two
ways:
OPTION A: Press and hold
the push button on both
hearing instruments for
about 3 seconds;
OR:
OPTION B: If you have a
compatible Remote Control
(optional), simply press the
streaming button.
Once the Clip-On Micro-
phone has been connected
an audible melody will play
in your hearing instruments.
This will be followed by ei-
ther the sound coming from
the Clip-On Microphone or
the sound coming from a
connected auxiliary audio
device (See section D).
A
B
C
GETTING STARTED
(Quick guide)
Clip-On Microphone
Before you can use your
Clip-On Microphone it is
necessary to:
• Charge your Clip-On
Microphone for at least
3 hours.
• Pair with your hearing
instruments.
NOTE!
Check with your
hearing healthcare profes-
sional to determine if your
instruments have been
pre-paired. Instruments
that have been pre-paired
do not need to be paired
again.
1.
2.
5.
4.
1.
On/Off
switch
3.
3.
It is possible to pair up to
three streaming accessories
with a given pair of hearing
instruments.
To pair a Clip-On Micro-
phone in channel 2:
• Follow steps 1 and 2
under
.
• Then press the pairing
button of the Clip-On
Microphone
TWO
times.
The LED indicator will
now blink yellow twice
every 2 seconds to indi-
cate that it is ready to be
paired in channel 2.
To pair a Clip-On Micro-
phone in channel 3:
• Follow steps 1 and 2
under
.
• Then press the pairing
button
THREE
times.
The LED indicator will blink
yellow three times every
2 seconds.
Finish by closing the battery
door on both hearing instru-
ments.
PAIRING THE CLIP-ON MICROPHONE IN CHANNELS 2 OR 3
PAIRING THE CLIP-ON MICRO-
PHONE IN CHANNEL 1
Streaming
button
2.
B
B
17766144-US-13.08-Rev.A.indd 1
16-08-2013 11:53:58