Resol WMZ Plus, Руководство по установке и эксплуатации, Страница: 19 / 24

19
en
In the Basic settings menu, all basic parameters for the device can be adjusted.
Normally, these settings have been made during commissioning. They can be subse-
quently changed in this menu.
Basic settings
Adjustment channel Description Adjustment range / selection Factory setting
Language Selection of the menu language Deutsch, English, Français,
Español, Italiano
Deutsch
Date Adjustment of the date 01.01.2001 … 31.12.2099 01.01.2012
Time Adjustment of the current
time 00:00 … 23:59 -
Auto DST Daylight savings time selection Yes, No Yes
Flow unit Volume unit l, m³ l
Bus mode Bus mode single / cascade op-
eration M.+C., Master, Slave 1 … 7 -
Reset back to factory setting Yes, No No
11 Basic settings 12 MicroSD card
SD card
Adjustment channel Description Adjustment range / selection Factory setting
Rem. time Remaining logging time - -
Remove card... Safely remove card - -
Save adjustments Save adjustments - -
Load adjustments Load adjustments - -
Logging int. Interval for data logging 00:01 … 20:00 (mm:ss) 60:00
Logging type Logging type Cyclic, Linear Linear
The device is equipped with a MicroSD card slot for MicroSD memory cards.
With a MicroSD card, the following functions can be carried out:
• Logging measurement and balance values. After the transfer to a computer, the
values can be opened and visualised, e.g. in a spreadsheet.
• Store adjustments and parameterisations on the MicroSD card and, if necessary,
retrieve them from there.
• Running firmware updates on the device.
Firmware updates
The current software can be downloaded from www.resol.de/firmware. When a
MicroSD card with a firmware update is inserted, the enquiry Update? is indicated
on the display.
Î In order to run an update, select Yes and confirm with the right button (
✓
).
The update will run automatically. The indication Please wait and a progress bar
appear on the display. When the update has been completed, the device will auto-
matically reboot and run a short initialisation phase.
Note
Only remove the card when the initialisation phase has been completed
and the main menu is indicated on the device display!