© RESOL 10263 flo
wcon_sensor
.monen.ind
d
F lo w C o n S e n s o r / S e n s o r H E
5
|
0,0
1,0
2,0
3,0
4,0
5,0
6,0
7,0
8,0
9,0
10,0
0
200
400
600
800
1000
1200
0
9,8
19,6
29,4
39,2
49
58,8
68,6
78,4
88,2
98
FlowCon Sensor / Sensor HE
Grundfos Solar PM 15-85
Wilo ST 15/6
Pump characteristic / pressure loss characteristic
F lo w C o n S e n s o r / S e n s o r H E
flow rate [l/h]
pr
essur
e loss [kPa]
pr
essur
e [mWS]
The installation and commissioning of the solar station as
well as the connection of electrical components requires
technical knowledge commensurate with a recognised
vocational qualification as a fitter for plumbing, heating and
air conditioning technology, or a profession requiring a com-
parable level of knowledge. The following must be observed
during installation and commissioning:
• the relevant regional and national regulations
• the accident prevention regulations of the trade association
• the technical and safety instructions of these instructions
Safety instructions
WARNING: Risk of scalding
There is a danger of steam emission with safety val-
ves. Therefore a discharge pipe must be connected
to the ¾“ internal thread of the safety assembly.
Please observe the enclosed instructions regarding
the safety valve when doing this.
Attention: Damage to property
The group of fittings must be installed with suffi-
cient spacing to the collectors because tempera-
tures in the vicinity of the collectors can be very
high. An intermediate vessel may be necessary for
installation in the attic.
Attention: Damage to property
It is imperative that you make sure the EPDM
sealing elements of the solar station do not come
into contact with substances containing mineral oil.
Mineral oil products cause lasting damage to the
material, whereby its sealant properties are lost.
If necessary, ask the manufacturer whether the
solar fluid, fats or installation aids contain mineral
oils.
The manufacturer does not assume liability nor
provide warranty for damage to property resulting
from sealants damaged in this way.