© RESOL 10263 flo
wcon_sensor
.monen.ind
d
F lo w C o n S e n s o r / S e n s o r H E
23
|
15. Main menu
To switch between info area and main menu, press button 3
for two seconds.
The main menu consists of the three submenus “Status”,
“Balance values” and “Adjustment values”.
Status
Loading
Flow temp.
65 °C
Return temp.
39 °C
Status
back ...
Max. flow temp.
73 °C
Max. return temp.
58 °C
Balance values
In this menu, the following balance values are displayed:
• Maximum flow temperature
• Maximum return temperature
• Maximum flow rate
• Maximum power
• Maximum pressure
• Minimum pressure
• Maximum temperature at S1
• Maximum temperature at S2
• Maximum temperature at S3
• Heat quantity
• Operating hours R1
• Operating days
Î
To switch back into the main menu, select “back ...”
15.1 Status
15.2 Balance values
1
2
3
downwards
SET
(select or confirm)
upwards
The balance values can be reset to zero in this menu. To
reset a balance value, proceed as follows:
Î
Select the desired balanced values by pressing buttons
1 and 2
Î
Briefly press button 3 to reset the value
The balancing of the value restarts at zero.
Resetting balance values
The status menu shows the current values for:
• Status
• Flow temperature
• Return temperature
• Flow rate
• Power
• Pump speed
• Pressure
• S1 ... S3
If the status displayed is “Standby”, “Pause”, “Identification”,
“Stabilising” or “Overrun”, the remaining time of the phase is
displayed as a countdown in a new menu line below “Status”.
If the status displayed is “Pause”, the menu line “
Skip
pause!
” appears below the countdown. Upon selecting said
menu line, the pause is aborted and the controller starts
an identification phase.
If several error and / or warning messages occur, only the
one with the highest priority can be displayed in the status
display of the info area. All further messages are displayed
in the status menu, marked with a triangle
.
The message “Flow rate?” can be acknowledged in this
menu.
Status
Balance values
Adjustment values
Main menu:
Î
To switch back into the main menu, select “back ...”
Note:
Aborting the pause can e. g. be helpful to check
the controller function right after the installa-
tion of the system.