resideo Braukmann KS30E-30, Руководство по установке

Страница: 12 / 86

GB
12 MU1H-1420 GE23 R0420
6 Troubleshooting
Attention:
If your water softener is not performing as it should, please run through the check list below.
If any overflow situation occurs or if any of the above
requires action reduce the water level and initiate a
regeneration by pressing and holding the manual
regeneration key [RECHARGE] for more than six
seconds.
Attention:
If your water softener is not performing as it should, please
run through the check list below.
If the home position is not detected within 10 minutes,
the main display will show an "Err 1" message to
indicate a controller error and an audible alarm will
sound. The error condition can only be cleared by
removing and re-applying the power.
CAUTION!
If problem persists, please call your local dealer or
after sales service team.
7 Spare Parts
For Spare Parts visit homecomfort.resideo.com/europe
Checklist Solution
Problem: Water still remains hard.
Is there a minimum of 150 mm of salt in the brine cabinet?
Fill the brine cabinet with salt.
Is the power on? Switch the power on and check connections.
Is the softener online?
Hydraulic problem during regeneration (e.g. pressure drop of
water). Close the by-pass valve and open the inlet and outlet valves.
Please restart the regeneration manually.
Is the hardness setting correct? Reset the hardness if required.
Problem: Water level in brine cabinet reaches overflow.
Is the line pressure within the specification of the water
softener?
Connect a pressure gauge to a water outlet and check the
pressure is between: 1.7 - 5.0 bar for the UK / 1.0 - 8.0 bar for
EU.
Pressure falls outside of the water softener specification. Fit a pressure reducing valve or booster pump as
required.(observe the note below)
Is there flow through the drain line? Check the drain line is not kinked, blocked or frozen.
Has there been a power interruption? Check that the power is on and the connections are secure.
Problem: No water.
Is the mains stop valve open?
Open the mains stop valve.
Are the inlet and outlet valves of the water softener open? Open the inlet and outlet valves to the water softener.
Checklist Solution
Problem: Water runs from the drain constantly.
Is the unit in recharge mode?
If yes, this is normal, wait until the recharge is complete.
Is the power on? There should be no flow to drain in the service position.
Problem: Excessive salt usage.
Check the hardness setting.
Reduce the hardness if incorrect.
Problem: Electronic Display.
The display shows error code: "Err 1", audible alarm sounds,
(see note below).
Check all the connections are secure. Turn the power off for 10
seconds then turn back on, allow the system to reset.
Is the digital display blank? Check the power is turned on and all the connections are
secure.
Problem: Unit regenerates at the wrong time.
Is the present time correct?
Reset the present time.